M3x20mm Round Head Bolt Phillips
Part no. BO3x20RHP
- On order: get it around Thursday 3 if you order today
- Free pickup in La Roca del Vallès · Mon-Fri 9:00-16:00
- Secure card payment · Visa, Mastercard, Maestro
- Returns within 14 days · Shipping and returns
Proasail.com is the official WASZP distributor.
Not sure it fits your boat? Write to us: the reference BO3x20RHP is already in the message.
Description
M3x20 mm Phillips round head bolt in 316 stainless steel, from the WASZP spare fastener range.
In the exploded diagram it is listed in the Bulkhead Fittings, position 8 (2 in that assembly), within the Hull and trolley group, and in the Tiller Mechanism Assembly, position 7 (2 in that assembly), within the Foils and rudder group.
It is used in two places: with the Harken Cheek block (HK432) on the bulkhead and with the tiller sliding gudgeon screw (WZTSGS). It is a small part, but if it is lost or damaged it is best replaced with the exact reference.
The tiller mechanism also has an M3 screw of a different length (BO3x16RHP), and the two are not interchangeable by eye: check the position in the exploded diagram before fitting it.
Fitting and use
Position in Bulkhead Fittings: 8 (2 pcs. per assembly)
Position in Tiller Mechanism Assembly: 7 (2 pcs. per assembly)
Use: with the Harken Cheek block HK432 (bulkhead)
Use: with the tiller sliding gudgeon screw, Tiller Sliding Gudgeon Screw WZTSGS (tiller)
Compatibility
Where it goes in the parts diagram
- WASZP parts diagram · Foils and rudder · Tiller Mechanism Assembly See it in the parts diagram ›
- WASZP parts diagram · Hull and trolley · Bulkhead Fittings See it in the parts diagram ›
Not sure it fits your boat? Write to us.
Specifications
| Reference | BO3x20RHP |
|---|---|
| Thread | M3 |
| Length | 20 mm |
| Head | round |
| Drive | Phillips |
| Quantity in Bulkhead Fittings | 2 |
| Quantity in Tiller Mechanism Assembly | 2 |
| Material | 316 stainless steel |
| Manufacturer | WASZP |
Frequently asked questions
Where on the WASZP is this screw fitted?
In the bulkhead fittings (position 8) and in the tiller mechanism (position 7). It is used with the Harken Cheek block HK432 and with the tiller sliding gudgeon screw.
How many BO3x20RHP screws does each assembly use?
There are 2 units in Bulkhead Fittings and 2 in Tiller Mechanism Assembly.
Can I confuse it with the tiller's M3x16 screw?
Yes, if you don't check the reference. The tiller mechanism also uses the BO3x16RHP in a different position. Look at the reference and the position in the exploded diagram, not just the appearance.
Downloads
- Hull and trolley exploded diagram (PDF) (opens in a new tab)
- Hull and trolley interactive exploded diagram · Bulkhead Fittings (opens in a new tab)
- Foils and rudder exploded diagram (PDF) (opens in a new tab)
- Foils and rudder interactive exploded diagram · Tiller Mechanism Assembly (opens in a new tab)
- Full WASZP exploded diagram (PDF) (opens in a new tab)
Recommended products
Similar parts




