RS Veleros and Renting Ribs are now PRO-A

Same team, same phone number, same services. All at Proasail.com.

What changes
Skip to content

Jib - Dacron furling complete Kit - Sail + Hardware

Complete Weta Dacron furling jib kit (Jib - Dacron Furling Complete Kit). Includes sail and hardware (Sail + Hardware).
incl. VAT: €897.49
excl. VAT: €741.73
On order Delivered within 15 days of order confirmation
Sold per unit
  • On order: get it around Thursday 3 if you order today
  • Free pickup in La Roca del Vallès · Mon-Fri 9:00-16:00
  • Secure card payment · Visa, Mastercard, Maestro
  • Returns within 14 days · Shipping and returns

Proasail.com is the official Weta distributor.

Not sure it fits your boat? Write to us: the reference 30500 is already in the message.

Description

Complete Weta Dacron furling jib kit (Jib - Dacron Furling Complete Kit - Sail + Hardware), part no. 30500. It includes the sail and the hardware (Sail + Hardware).

The Dacron furling jib system is based on replacing the forestay with the furling jib and tensioning the rig as usual. If you already have the Dacron furling jib, no further parts are needed, apart from a short length of rope for the lashing. You will need to fine-tune the length of the top strop the first few times you rig the boat, because it stretches slightly. Once adjusted, it does not need doing again. Over time the components stretch a little and rig tension is lost. You then need to tighten the lashing between the top swivel and the swaged T-ball terminal.

The top swivel of the furler is shackled to the eye at the head of the jib. The swaged T-ball terminal is then lashed to the swivel. That length is set during the initial fitting to get the correct rig tension. The tack of the jib is attached to the lower drum of the furler. The T-ball hooks into the mast as if it were the forestay. The jib halyard is not fitted. With the jib furled, tie a rope around the clew so that it does not unfurl.

Weta spare part, Sails section.

Fitting and use

The top swivel is shackled to the head and the swaged T-ball terminal, lashed to it, hooks into the mast like the forestay. The tack goes to the drum; the jib halyard is not fitted. Adjust the top strop the first few times, because it stretches a little.

Compatibility

Listed in the Weta parts diagram.

If you already have the Dacron furling jib, all you need is a short piece of line for the lashing.

Which boats it fits

Not sure it fits your boat? Write to us.

Specifications

What's includedThe sail and the furler hardware (Sail + Hardware).
Sold asSold as a complete kit.
Technical dataPart number 30500, made by Weta Marine.
ClothDacron.
SectionSails.

Product safety

Manufacturer
Wētā Marine · Campbells Bay, North Shore, Auckland, New Zealand · info@wetamarine.com
EU responsible person
PROASAIL, S.L. · Av. València, 82, 08430 La Roca del Vallès (Barcelona), Spain · info@proasail.com

Frequently asked questions

Can I buy just the sail or just the hardware?

Yes: the range has the sail on its own, 30505 (Jib - Dacron Furling - Sail Only), and the hardware on its own, 30510 (Jib - Dacron Furling - Hardware Only). This 30500 is the kit with both (Sail + Hardware).

How do I set the drum height on first fitting?

Lash the line to the bow strop as low as possible, pull on rig tension and measure the bottom lashing. Drop the mast and extend the top lashing by that same length, so the drum sits as close to the deck as possible. Raise the mast again and check; if it is not right, repeat.

Do I have to furl the jib before raising the mast the first time?

It is not essential, as the mast can be raised with the jib unfurled, but it is recommended if there is any wind. Tie the head to an anchor point, tension the luff by tying off the tack and wrap the clew around the jib until it is furled; then tie it off.

Is the mast harder to raise with the furling jib?

A little: you raise it with the Dacron jib furled in place, so it is slightly heavier and has more windage than with the standard rig. If it is hard in strong wind, turn the boat stern to the wind or rig it on a slight downhill slope, bow pointing down.

Downloads

Recommended products

More parts for this boat and similar parts

Your cart

Loading…

Sign in

Check out as a new customer

Creating an account has many benefits:

  • See your order and delivery status
  • Track order history
  • Check out faster