Mast step
Part no. 20351
- On order: get it around Thursday 3 if you order today
- Free pickup in La Roca del Vallès · Mon-Fri 9:00-16:00
- Secure card payment · Visa, Mastercard, Maestro
- Returns within 14 days · Shipping and returns
Proasail.com is the official Weta distributor.
Not sure it fits your boat? Write to us: the reference 20351 is already in the message.
Description
Weta mast step (Mast Step), part no. 20351. Weta spare part, Spars section.
Before stepping the mast, check that nothing is blocking the mast step and that the shrouds are free. Then lift the mast, rest it on the launching trolley and place it in the mast step.
If you fit the 2022 self-tacking jib kit, the straight-edged moulding of the self-tacker is placed hard up against the mast step, without overlapping it. In step 1b of the fitting, place the recessed part of the moulding against the mast step, keeping the midpoint 25 mm from the mast. Important: the self-tacker must not overlap the mast step. The mast step bar is also the point where one end of a line is tied off.
Fitting and use
Before stepping the mast, make sure nothing covers the step and the shrouds run free; the mast is raised, rested on the trolley and then dropped into it. With the 2022 self-tacking jib kit, its moulding is bonded against the step, not on top of it, with its midpoint 25 mm from the mast.
Compatibility
Listed in the Weta parts diagram.
Which boats it fits
Not sure it fits your boat? Write to us.
Specifications
| Technical data | Part number 20351, made by Weta Marine. |
|---|---|
| Section | Spars. |
| Technical data | The mast step bar also works as a tie-off point for a self-tacker line. |
Product safety
- Manufacturer
- Wētā Marine · Campbells Bay, North Shore, Auckland, New Zealand · info@wetamarine.com
- EU responsible person
- PROASAIL, S.L. · Av. València, 82, 08430 La Roca del Vallès (Barcelona), Spain · info@proasail.com
Frequently asked questions
I am fitting the self-tacking jib: which kit sits against my mast step?
It depends on the hull number. From 1000 upwards, 30304: the straight-edge moulding goes hard against the mast step, without overlapping it. From 1 to 999, 30305: recessed moulding, with its midpoint 25 mm from the mast.
How do I put the mast in the mast step when it is windy?
Put the stern to the wind. Stand the mast up on the ground, rest it on the trolley support and take it to the mast step with the forestay in your lower hand.
What should I check before stepping the mast, apart from the mast step?
Look up: there must be no power lines, because the carbon mast conducts electricity.
Downloads
Recommended products
More parts for this boat and similar parts









